The Pathway so far...

At the moment all the steps that have been done from the expectations are:

-The side finger joints- 
1. first the wood was measured to size and labelled (A,B,C,D) to make sure all the pieces went together properly          
2. They were cut according to the lines measured
3. Then the joint outline was drawn
4. The lines were cut and some were cut out from the side, others chiseled from the middle
                       
-It all fits-

-The side slots-
1. first the outline was drawn
2. lines cut and the center chiseled out

-It is all glued and clamped together-

Expectation

In the Beginning

We were given the task to make a naughts and crosses box. To start a sketch up and a orthographic draw was made, to scale.

It was told the box shall be 183mm x 183mm x 33mm. The small naughts and cross will be 42mm x 42mm x 40mm.  

Expectation - Translation - It should look like this

To start this off a sketch-up was done and an orthographic drawing was done to give a ruff idea was what it will look like.